Macrosystem Bogart SE Ver.2 User manual Bedienungsanleitung PDF herunterladen (Seite 97)

100

Bogart SE 2 user manual

You can set up the audio offset range if your TV set requires

more time for audio than your audio receiver. Simply try out

different values to ﬁnd the best for your needs.

3.3.3. Start melody

Activate or deactivate the melody that is played when the sy-

stem (Media Manager) starts. You can also deﬁne the correc-

tion volume. 0dB is the current volume.

3.4 Connections

Depending on the device used, this is where you decide on

the format for the top SCART connection (TV): Activate either

CVBS+RGB or YC. You can also set up the bottom SCART

connection (Video). Make sure to choose the right setting to

avoid a monochrome image. If you can‘t see the picture or if

the image is shown incorrectly, the system will return to the

previous mode after 10 seconds.

3.5 Parental Control

There are three options: `Youth protection off´, `Youth protec-

tion active´ and `Lock all functions´. Use `Safety method´ to

set up the youth protection key. Press the respective number

button to choose `Enter/change Parental Control PIN´, `Use Pa-

rental Control PIN´, `Use dongle´ and `Register/change dongle´.

At the time of writing this manual, there are only 2 available

options: 1) Fully locking the device once you power down the

system from the Media Manager. Press 2) Options - allowed

media - Archives and Change Settings to lock certain Media

Manager settings. Also: You can lock the front ON/OFF button.

Note: Powering the unit up is then only possible using the

remote control.

3.6 Device

Here, you can set up the `Power Savingr´ mode. Deactivate it

completely (`Never´), so that the device is not powered down

completely. This has the advantage that the unit starts up

faster. You can also set up the display brightness modes for

standby or in use. If you set up both display and power saving

to `immediately´, the Casablanca will go into standby mode

right away when switched off. Please note that some units may

not have a 0-Watts standby operation. This also only works

after a device has been connected to the power line for at least

a day. In 0-Watts use, the display dœs not show the time. In

addition, you can also reduce the „noise management“ noise

by changing the setting in `DVD/Blu-ray drive´.

1 2 ... 92 93 94 95 96 97 98 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Macrosystem Bogart SE Ver.2 User manual Bedienungsanleitung Seite 97

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Macrosystem Bogart SE Ver.2 User manual